Elenco Electronics rc snap rover Bedienungsanleitung PDF herunterladen (Seite 30)

-29-

Project #58

OBJECTIVE: To show that motors and lamps may sometimes be

used as ordinary conductors.

Turn on the slide switch (S1) and tap the whistle chip (WC), it makes

a machine gun sound (with music in the background). Thoroughly

cover the photoresistor (RP) with your hand and the sound becomes

a siren. After a while the sound will stop, tap the whistle chip and it

resumes.

Press the press switch (S2) and the LED (D1) lights, but the lamp (L1)

does not light and the motor (M1) does not spin. Electricity is flowing

through the lamp and motor, but not enough to turn them on. So in this

circuit they are acting like 3-snap wires.

Using Parts as

Conductors

Project #57

OBJECTIVE: Build an electronic game for racing.

Modify Project #56 by adding the pointer as shown on the left. The paper should be

cut from page 46 and taped high enough on the speaker (SP) so the pointer will stick

over the fan (M1) with paper. Bend the pointer at a right angle as shown on the left.

Setup: Cut out the grid with four (4) colors from page 46 and place it under the

base as shown on the left. Each player picks a color (or two colors if only 2 people

are playing) and places a single snap on row G. The purple player in column 1,

the blue player in column 2, the green player in column 3, and the yellow player

in column 4. Spin the wheel by closing the press switch (S2). The first single

color wedge that the pointer points to is the first player to start. In some models,

you only have three 1-snaps, so use a 2-snap if you have four players.

The Play: Each player gets a turn to press the press switch. They release the

press switch and when the pointer points to a wedge the players that match the

colors on the wedge get to move up one space. If a liner comes up like the one

shown on the left then the players on each side of the line get to move up two (2)

spaces. The first player to reach the top row (A) wins. If two players reach the

top row at the same time they must both drop down to row “D” and play continues.

Race Game

WARNING: Moving

parts. Do not touch

the fan or motor during

operation.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 47 48

Keine Kommentare

Elenco Electronics rc snap rover Bedienungsanleitung Seite 30